60 HyPrecision Predictive waterjet pump Operator Manual 810120
4 – Operation
Operation
Operate the pump remotely
Turn on the pump
The pump is on when the primary motor is operating.
The primary motor drives 2 pumps. A hydraulic pump moves hydraulic fluid to the intensifier. A gear pump moves
hydraulic fluid through the cooling loop.
1. On the operation panel, make sure that the key switch is set to L
OCAL.
2. Push the C
ONTROLS ON button
3. Turn the key switch to R
EMOTE.
Start the pump
Refer to the OEM’s instructions for turning the pump on.
Operate the pump
Refer to the OEM’s instructions for operating the pump from a remote source.
Stop the pump
Refer to Stop the pump on page 67.
To Next Page
Need help?
General
