Need help?Do you have a question about the Hypertherm HyPrecision Predictive P-50S and is the answer not in the manual?
General| Brand | Hypertherm |
|---|---|
| Model | HyPrecision Predictive P-50S |
| Category | Water Pump |
| Language | English |
Introduction to the HyPrecision Predictive Waterjet Pump series.
Identifies the specific pump models P-15 through P-75S.
Introduction to the pump's components and features.
Instructions and guidelines for operating the waterjet pump.
Critical safety precautions to follow during maintenance.
Detailed schedule of preventive maintenance tasks and intervals.
Guidance for diagnosing and resolving pump problems.
Detailed technical specifications for each pump model.
Instructions for installing the waterjet pump and its related systems.
Table of orifice sizes in metric and customary units.
Recommended torque values for various connections.
General steps for installing the pump and optional equipment.
Procedure for safely connecting electrical power to the pump.
Comprehensive steps for the initial startup of the pump.
Procedure to ensure correct primary motor and fan motor rotation.
Procedure for flushing the pump and high-pressure tubing.
Navigating and configuring pump settings via the operator interface.
Adjusting timers for pump start and stop sequences.
Adjusting pressure settings and configuring remote operation.
Configuring fault behavior and Seal Maintenance Indicator settings.
Detailed descriptions of key high-pressure system components.
Essential steps to perform before starting pump operation.
Instructions on operating the pump using its controls.
Understanding the various screens on the operator interface.
Methods for safely stopping the pump, including emergency stop.
Comprehensive schedule of preventive maintenance tasks and intervals.
Detailed procedures for maintaining the high-pressure intensifier.
Procedures for removing, disassembling, and assembling the bleed-down valve.
Using the operator interface for maintenance logging and status.
Steps for starting the pump after maintenance is completed.
Identification and explanation of pump alarms and fault conditions.
Description of warning messages and their potential causes.
Detailed troubleshooting steps for common fault codes.
Troubleshooting issues related to intensifier control and stroking.
Diagnosing and resolving problems causing short high-pressure seal life.
Addressing issues related to hydraulic fluid temperature.
Diagnosing and resolving problems with system pressure.
Methods for identifying and fixing various types of leaks.
Diagnosing and resolving issues related to water pressure.
Troubleshooting problems associated with the boost pump.
Interpreting and resolving SMI-related alarms.
Troubleshooting warnings or faults during the pump start sequence.
To Next Page
