Hypertherm HyPrecision Predictive P-50S - Time, Date, and Intensifier Control Settings

HyPrecision Predictive waterjet pump Operator Manual 810120 223
9 – Installation
Installation
Enter or change the time and date
Change the date and time that is shown on the operator interface.
Intensifier Control
Touch this symbol to change the time format. Select a 12-hour clock or a 24-hour clock.
Touch this date symbol to change the date format.
Select DD-MM-YY or MM/DD/YY.
Time field and
date field
Touch this field to open a keypad.
Touch the up or down arrows to change the value.
Intensifier On This turns the intensifier on or off.
If intensifier control is off, the primary screen shows a red X on the intensifier symbol.
Do this task when the pump is running in cooling mode or is turned off.
Overstroke Touch this field to open a keypad.
Enter the maximum overstroke percentage permitted before a fault occurs.
The default is 5%.
1
2
1
Time field
2
Date field