Hypertherm HyPrecision Predictive P-50S User Manual

196 HyPrecision Predictive waterjet pump Operator Manual 810120
9 – Installation
Installation
Buyer responsibilities
The buyer is responsible for these obligations:
 Cooperate with Hypertherm and the Hypertherm original equipment manufacturer (OEM) regarding the
installation of the equipment.
 Obey all setup and first-time start up instructions in this manual.
 Research and obey all local codes, including requirements for waste water disposal.
 Install high-pressure tubing.
 Install water-treatment equipment before the pump is installed.
 Make sure that all utilities are available during installation. The site must have sufficient electrical power,
air, water, and drain access.
 Make all connections to the pump.
 Fill the hydraulic fluid tank. Hypertherm does not always ship the pump with hydraulic fluid in the tank.
 Perform user qualification and training. Refer to User qualification and training on page SC-22 for
information.
WARNING
This pump can supply water pressure of up to 4,140 bar (414, 000 kPa / 60, 000 psi). Only use
tubing that is rated for this pressure.
WARNING
Use supports for plumbing to prevent damage to plumbing from bending stress and fatigue from
vibration.

Hypertherm HyPrecision Predictive P-50S Specifications

General

Brand	Hypertherm
Model	HyPrecision Predictive P-50S
Category	Water Pump
Language	English