DO NOT:
Put hands on the gantry rails. You will lose fingers!
Cut these materials due to TOXIC fumes :
Anything cleaned with chlorinated cleaner (e.g. brake cleaner)
–PHOSGENE gas is generated
Galvanized steel – causes “galvanize poisoning”
Heavily painted material – causes arc degradation and
unpleasant if not dangerous offgassing
Watch the arc without proper safety gear – AWS recommends
shade 8 or greater eyewear
Handle material without proper PPE/Tools – hot material after
cutting will BURN
Abuse the equipment (e.g. misusing the torch by placing the cutting
head over your hand & pulling the trigger)
Safety First!!!
To Next Page
Loading...
