The Equipment – Hypertherm powermax 1000
Selecting Amps, cut speeds, etc.
The black book kept with the Hypertherm power supply will be an
appropriate starting point. However, you should consult the wiki
(https://dallasmakerspace.org/wiki/CNC_Plasma_Cutter_Training#Equip
ment) for more up-to-date information about the DuraMAX torch.
Always TEST.
Things can change, so pick a scrap section of your stock, and do a test cut
or 2 (or however many you need to make sure it’s working as you desire)
To Next Page
Loading...
