If stock needs to be repositioned after a cut has been made, for example, to avoid stanchions,
make reference cuts in the stock which are the diameter of the shield
Use the PlasmaCAM software to draw a circle or two for reference before making any
other cuts
Select a scrap area of the stock
When drawing the circle, enter the size of the shield for the diameter
Draw/cut a second circle for more precise re-location
In the PlasmaCAM software move the torch to the reference position(s)
Move the stock so the torch and the reference holes in the material line up whenever
initiating a new series of cuts
Other Information – Reference Cuts
To Next Page
Loading...
