36 © Copyright 2019 HYPERVSN. All rights reserved
10. SAFETY PROVISIONS
WARNING! The Device must be installed so that the lower edge of the rays is at least 2.9m off
the floor. Exceptions are allowed in case there is a natural barrier or similar preventing the
public from approaching the Device any closer than 2m.
The additional safety requirements that have not yet been mentioned above are outlined below:
The Device belongs to class 1 in regard to protection against electrical injuries. Operating the Device
without the proper grounding is strictly prohibited.
To avoid injuries of an electrical nature, never turn the Device on while the stator safety cover is
removed.
The power voltage where being operated must match the information on the Device type label.
Under NO circumstances touch the Device while the rays are rotating. The rays on the rotor become
effectively invisible, which might pose a danger and cause injury.
Since the HYPERVSN Display relates to TYPE A pluggable equipment it is necessary to have an easy-
to-reach socket nearby.
After using the Device, the stator and rotor elements can become hot to touch. Please wait until the
temperature drops before touching or handling the Device components.
Do not throw any objects towards the Device.
Do not use the Device if the power cord is damaged. Make sure the cord is not in contact with any
sharp edges or hot surfaces.
Do not pull on the power cord or wind it around any part of the Device.
If the Device produces any abnormal sounds during operation, please stop using the Device
immediately and contact the vendor.
Do not let children play with the Device and do not leave them unattended in close proximity to an
operating Device. This is not a toy. Small parts may present a choking hazard for children.
Do not disassemble the remote control. If the remote control operation guidelines are not followed,
the batteries could pose danger.
When the Device is in operation, keep the Device power cord as far away from the rotating elements
(the rotor and the rays) as possible. You can also use wiring duct that matches the color of the
mounting surface.
The Device requires an attention-label nearby. Please download the label from the following page:
https://hypervsn.com/downloads/WARNING_Sticker_device.pdf
Attach the warning label in a close proximity to the Device.
To Next Page
Loading...