5 HMS-600W / 800W USER MANUAL
2. Place the shield between the Micro Inverter and the receiving antenna, such as
metal.
3.Consult the dealer or an experienced radio/TV technical for help.
Changes or modifications not expressly approved by the party responsible for
compliance may void the user’s authority to operate the equipment.
1.2 Safety requirements
Only qualified personnel can install and replace inverters
Before installing or using the Micro Inverter, please read all instructions and
cautionary markings in the technical documents and on the Micro Inverter system and the
solar-array
Perform all electrical installations in accordance with local electrical codes
Do NOT disconnect the PV module from the Micro Inverter without disconnecting
the AC power.
Be aware that the body of the Micro Inverter is the heat sink and can reach a
temperature of 80°C. To reduce risk of burns, do not touch the body of the Micro
Inverter.
Do NOT attempt to repair the Micro Inverter. If it fails, contact Customer Support
(+86 400 6339 990) to start the replacement process. Damaging or opening the Micro
Inverter will void the warranty.
Do NOT expose the connection to directed, pressurized liquid (water jets, etc.).
Do NOT expose the connection to continuous immersion.
Do NOT expose the AC connector to continuous tension (e.g., tension due to pulling
or bending the cable near the connection).
Do NOT allow contamination or debris in the connectors.
Use only the connectors and cables provided.
Use the cable and connectors only when all parts are present and intact.
Use the terminator to seal the conductor end of the Engage Cable; no other method
is allowed.
The external protective earthing conductor is connected to the inverter protective
earthing terminal through AC connector.
When connecting, connect the AC connector first to ensure the inverter earthing
To Next Page
Loading...
Need help?
General