Mount HyNet Assembly to StrongArm (HTG)
Lift StrongArm chassis cover
and set it aside.
1
2
Peel protective paper off
Velcro
®
strip.
NOTE: If necessary,
use the key to unlock
the StrongArm door
panel.
3
Adhere the Velcro
®
strip to the top
shelf inside of the StrongArm chassis.
Press rmly.
NOTE: Recommended HyNet
location is shown in the illustration.
Ambient temperature for adhesion is
between 45˚ and 85˚ F.
4
Set the HyNet onto the chassis
shelf so the ports are accessible
as shown in the illustration.
5
Press rmly to engage the
Velcro
®
loops and hooks.
6
Connect wiring.
See page 6.
Door panel
7
Replace chassis cover
and secure gate operator.
www.SecureOpeners.com | (800) 878-7829 | Sales@SecureOpeners.com
To Next Page
Loading...
