28
6.6.3 Ending a Phone Call
Conventional mode
A phone call ends in either of the following cases:
The calling party hangs up.
The called party presses the P6/End key (with the One-Key Connect feature enabled) or enters the disconnect
code.
Trunking mode
A phone call ends in any of the following cases:
The calling party presses the P6/End key or places the palm microphone back to the hanger.
The call duration preset by your dealer expires.
The base station signal is lost.
A preemptive or emergency call interrupts the call.
The calling party changes the contact with the Clear Down feature enabled.
6.7 Call on Analog Channel (Conventional Only)
6.7.1 Call without Signaling
On an analog channel without signaling, you can initiate a call to all the other users on the channel. Do as follows:
1.
Rotate the Smart knob to select the channel.
2.
Press and hold the PTT key on the palm microphone.
6.7.2 Call with Signaling
On an analog channel with signaling, you can initiate a call to a specific contact on the channel. Do as follows:
1.
Go to Menu > Contact > Favorite/Contact, or press the preprogrammed Contact List key.
2.
Select the contact.
3.
Press and hold the PTT key or the preprogrammed One Touch Call key.
To Next Page
Loading...
