If you do not want to hear activities on the channel, press the preprogrammed Nuisance Temporary Delete
key to remove the channel from the scan list temporarily.
8.4.1.2 Setting the Scan List
The scan list is a list of up to 32 analog and digital channels that the radio scans.
Go to Menu > Scan, select the scan list, and then do one of the following:
Select Add CH, and then press the OK/Menu key to add a new channel to the list.
Select Set Default, and then press the OK/Menu key to set the list as the default scan list for the current
channel.
Select View Record, and then press the OK/Menu key to view or manage all channels on the current list.
If you do not need to scan, you can delete all channels other than the current channel. If you want to
preferentially hear the activities on a channel, you can select the channel, and then select Set PrioCH-1 or
Set PrioCH-2.
8.4.2 Trunking Mode
8.4.2.1 Pre-registration Hunt
Before registering, the radio hunts through the control channels for available BSs. Two hunting plans are adoptable:
Fixed Trunking Station Control Channel (Fixed TSCC) and Flexible Trunking Station Control Channel (Flexible
TSCC). If the radio has unified frequency plans, it uses the Fixed TSCC; otherwise, it uses the Flexible TSCC. With
the Fixed TSCC preset, you can select the hunt modes as listed in the following table.
This feature allows the radio to hunt the fixed TSCC in
the defined hunt list.
Go to Menu > Scan > TSCC Hunt,
select Short Hunt, Comprehensive,
or Team1, and then press the
OK/Menu key.
This feature allows the radio to hunt all the channels
within the preset frequency range.
This feature allows the radio to hunt the fixed TSCC in
the defined team hunt list.
To Next Page
Loading...
