34
8.1.2.6 ESN Check in Idle (Trunking Only)
The ESN Check in Idle feature allows the radio to respond to the ESN check from the trunking system when the
radio is registering or after the radio has registered.
Go to Call Settings > ESN Check In Idle, and then press the OK/Menu key to do either of the following:
Enable the feature.
The radio responds to the ESN check both during registration and after registration.
Disable the feature.
The radio responds to the ESN check only during registration.
8.1.2.7 Call Priority (Trunking Only)
The Call Priority feature allows you to set the priority of all voice services except emergency calls. The priority
levels include Low, Medium, High, and Preemption (with the Preemptive Call feature enabled by your dealer).
When all channels are occupied, the call requests are put in a queue according to their priorities. When a channel
is released, the call with a higher priority will be connected prior to the call with a lower priority.
During group call queuing, only the calling party receives the queuing prompt. During private call queuing, both
the calling party and the called party receive queuing prompt. When the queue is full, the higher-priority calls can
jump the queue, and the lower-priority calls will be extruded out (the system will prompt that it is busy)
accordingly.
Go to Call Settings > Priority, select the priority level, and then press the OK/Menu key.
8.1.2.8 Any Call (Trunking Only)
The Any Call feature allows the radio to initiate a call to a contact whose ID is not in the contact list.
Go to Call Settings > Any Call, and then press the OK/Menu key to enable or disable Private ID.
With Private ID enabled, you can call any private contacts.
With Private ID disabled, you can call only the private contacts in the contact list or emergency
contact.
Go to Call Settings > Any Call, and then press the OK/Menu key to enable or disable Group ID.
With Group ID enabled, you can call any group contacts except that of the background group.
With Group ID disabled, you can call only the group contacts in the contact list, dynamic group, or
emergency contact.
Go to Call Settings > Any Call, and then press the OK/Menu key to enable or disable Phone.
To Next Page
Loading...
