Hytera HM782 - 8.1.3.3 Lone Worker; 8.1.3.4 TF Card Recorder

36

Adding an Encrypt Key
Go to Security > Encrypt > New Key, specify the key-related parameters, and then press the OK/Menu
key.
The following table describes the key-related parameters.
Parameter
Description
Key ID
The ID for each key must be unique. The value ranges from 1 to 255.
Key Alias
The key alias is composed of letters, digits, and special characters.
Key Length
The key length can be 10 characters, 32 characters, or 64 characters.
Key Value
The key value is composed of digits and letters and within the key length.

Selecting the Encrypt Key
Go to Security > Encrypt > Key List, select the encrypt key, and then press the OK/Menu key.

In trunking mode, you can select the encryption type.
Go to Security > Encrypt > Encrypt Service, set the encryption type to Only Voice, Only Data, or Voice
and Data, and then press the OK/Menu key.
8.1.3.3 Lone Worker
The Lone Worker feature allows the radio to automatically send an emergency alarm to your companion or the
control center in either of the following scenarios:

You do not operate the radio within the preset time.

The radio does not transmit voice within the preset time.
You can press the keys, rotate the knob, or transmit voice to exit the emergency mode.
To enable or disable this feature, do either of the following:

Go to Security > Lone Worker, and then press the OK/Menu key.

Press the preprogrammed Lone Worker key.
8.1.3.4 TF Card Recorder
The Recorder feature allows you to record live sounds and calls to the TF card and manage the recording files stored
in the TF card.
The Recorder feature is enabled by your dealer.