8
Instructions
z The radio operates with negative grounded power supply of 13.2 ± 15％V only.
Please check polarity and voltage of the power supply on vehicle before you install
the radio.
z Please check how long the screws will extend from the bottom surface of radio,
before you install the radio. Be sure to drill mounting hole with caution, to avoid
damage of the vehicle wiring and parts.
z Please connect the supplied antenna and power cord to the radio, before you install
the radio in the bracket.
z Install the radio with Hytera supplied mounting bracket, to avoid radio loose in case of
accidents. The loose radio may cause bodily injury.
z Install the radio in a location where it’s easy to reach the front panel controls.
z Please make sure there’s sufficient space at back of the radio for wiring.
z When the fuse for DC power cord needs replacement, it must be replaced by a fuse
with the same specification.
Installation Tools
z Electric drill
z Cross head screwdriver
z Hex socket sleeve (used for 4.8*20mm self-tapping screws)
Installation Steps
1. Install the bracket in a location where it’s easy to operate the radio.
2. Connect accessories such as antenna and power cord to the radio.
3. Slide the radio into the mounting bracket and secure it using the locking knobs.
4. Install the microphone hanger in a location where it’s easy to reach the microphone.
5. Plug the palm microphone into the microphone jack on the front panel, and then place
it on the hanger.
To Next Page
Loading...
Need help?
General
