27
To exit the Emergency mode, long press the programmed Emergency key.
Emergency Alarm with Voice to Follow
Operation:
1. Press the programmed Emergency key to send alarm information. The mobile radio
displays icon
and text information “Sending Alarm!”, with red LED glowing.
2. After an ACK is received (an alert tone sounds, and the mobile radio displays icon
and text information “Success”, with red LED flashing), and icon
appears, you can speak into the microphone to make an emergency call.
3. When icon appears, you can receive. And when a call is received, the icon
appears.
If the preset voice cycles expire, you can press the PTT key to make the emergency call
again (the mobile radio displays icon
, with red LED glowing). After the emergency
call is transmitted, please release the PTT key to receive (the icon
appears). When
a call is received, the icon appears.
To exit the Emergency mode, long press the programmed Emergency key.
Note: Your dealer may set the number of voice cycles, duration of each cycle and Tx
interval.
Ignition Sense
The following options are available via the vehicle ignition. You may ask your dealer to
assign any one to your mobile radio.
z PTT Disable: The PTT key is enabled or disabled by following the ignition sense.
Operation: To enable the PTT key, start the engine; to disable the PTT key, stop the
engine.
z Ignition or Switch: The mobile radio powers on or off by following either the ignition
To Next Page
Loading...
