22
Public Address
This feature allows public addressing via the external speaker. After the feature is enabled,
your voice will not be transmitted, but output via the external speaker (connected to the
accessory jack on the rear panel) if you hold down the PTT key and speak.
Operation:
1. Press the programmed Public Address key to enable the feature.
2. Hold down the PTT key and speak into the microphone. Then your voice will be
broadcasted clearly via the external speaker.
3. To disable the feature, press the function key again.
Note: When the feature is enabled, you cannot transmit or receive, nor can you
enter the menu.
Talk Around
You can continue to communicate in DMO mode by pressing the programmed Talk
Around key, when your repeater malfunctions, or when your terminal is out of the
repeater’s range but within talking range of other terminals.
Operation:
Press the programmed Talk Around key to switch between DMO mode and RMO mode.
Note: Under DMO mode, the two terminals must be within talking range of each
other.
Monitor
To adjust match conditions for signal receiving, you can enable the feature “Monitor”.
Operation:
(1) Press the programmed Monitor key to enable the feature, and the mobile radio
displays icon
. To disable the feature, press this key again. Or
To Next Page
Loading...
Need help?
General
