Hytera MT680 - Dmo

16
Selected List
You may transmit calls to any member included in the
Selected List. To transmit a call to a talk group, you need
to select this group through knob or menu, and then
hold down the PTT and speak into the microphone. The
selected default group will be marked with .
Scan List
To receive calls from a specific talk group, you must
include it in the Scan List, and set Scan on. See the
following gure for an overview of the menu:
Scan Off: to disable scan.
Scan: to activate scanning.
Menu Navigation
Note: Scan List is available for TMO mode only.
You can receive calls from any member included
in the Scan List, but cannot transmit calls to such
member. To transmit calls to a specific talk group,
you need to include it in the Selected List.
Static Folder
Static folder contains available talk groups, and is
predened by your dealer Your terminal supports up to 20
static folders, each with up to 20 talk groups. Talk groups
contained in static folders could be identical or different.
After accessing any of the folders, you can perform the
following operations:
Add: to include a talk group into the current folder;
Delete: to remove a talk group from the current folder;
Delete All: to remove all talk groups from the current
folder;
As SltList: to add all talk groups in the current folder to
Selected List;
As Scan List: to add all talk groups in the current folder to
Scan List;
DMO
In DMO mode, this option shall be TMO. You can use this
option to make your terminal work in DMO mode.