17
Troubleshooting
Phenomena Analysis Solution
Power-on Failure.
The battery may be improperly installed. Remove the battery and then attach it.
The battery power may be used up. Recharge or replace the battery.
The battery may be poorly connected due to
dirtied or damaged battery contacts.
Clean the battery contacts. If the problem cannot be solved,
contact your dealer or authorized service center for inspection
and repair.
During receiving,
the voice is weak,
discontinuous or totally
inactive.
The battery voltage may be low. Recharge or replace the battery.
The volume level may be low. Increase the volume by pressing the Volume +/Right key.
The speaker may be blocked or damaged.
Clean the surface of the speaker. If the problem cannot be
solved, contact your dealer or authorized service center for
inspection and repair.
Unable to communicate
with other members.
The frequency or signaling may not match that of
other members.
Set your TX/RX frequency and signaling to the same as that of
other members.
The channel type (digital/analog) may be set
inconsistently.
Make sure all members are on the same digital/analog channel.
You may be too far away from the group
members.
Move towards other members.
Irrelevant
communication or noise
is heard on the channel.
You may be interrupted by radios using the same
frequency.
Change the frequency, or adjust the squelch level.
The radio may be set with no signaling.
Set signaling for all member radios to avoid interference at
the same frequency. And change the signaling settings for all
portable radios at the same time.
If the solutions blow cannot x the problems, or there are other questions, please contact us or your local dealer for more technical support.
To Next Page
Loading...
Need help?
General
