Hytera DMR System Planner
110
3.4 RDAC (Repeater Diagnostics and Control)
RADC is designed to facilitate the use of the new generation digital repeater. This
software can be installed and operated on the following systems: Windows XP,
Windows vista and Window 7 series 32-bit.
RDAC is designed to by Hytera remotely diagnose and control the repeater. With
RDAC, the repeater can work in normal state longer, and when any problem occurs,
immediate maintenance will be carried out. It does good to cost effectiveness and
the use of repeater in retransmitting communications.
RDAC plays a great role in the remote diagnosing and control. In terms of
diagnosing, control as well as setting and log. It can diagnose the voltage,
temperature, fan, TX power, RX power, VSWR, RX PLL state and TX PLL state. It
can remotely control the repeater, forbid re-transmitting, disable the repeater and
enable the repeater. It can remotely configure various parameters of the repeater. It
can automatically produce the alarm report and diagnosing log to facilitate the user
to know the accidences.
Network support
It surpasses the software of a kind. It enables multiple masters (up to 16), every of
which can support up to 30 slaves to work in the IP network. After the RADC
connects with the master, it can get the IP address of the slaves. Thus, it can
effectively and efficiently diagnose and control the master and the slaves at the
same time.
Access Management
Access management has two types: Local Access Management and Multi-site
Access Management. Such kind of management can optimize and better utilize the
retransmission function,
Customization
Multiple versions of Hytera RDAC software are available. You can choose one for
your need.
To Next Page
Loading...
Need help?
General
