Hytera DMR System Planner
155
4.7 Phone Interconnect
On the basis of the existing PSTN system, the Phone feature can enable
communication between the mobile terminal and the phone by either connecting the
local PSTN gateway via the repeater and then the phone system, or using the
remote PSTN gateway via the IP Multi-site Connect feature.
The Phone feature is supported in both analog and digital mode. Only the digital
mobile terminal and repeater in digital mode can realize the Phone feature via IP
Multi-site Connect feature. The Phone feature can allow the terminal in the system
to talk with a phone only during a specific time period.
4.7.1 Phone Applications in Local Mode
4.7.1.1 Call from Terminal to Phone
Figure 4.7.1.1-1: Call from Terminal to Phone
Call process:
1. The terminal sends the Access Code to access the phone system. Afterwards, it
receives sound similar to the off-hook tone from the phone, indicating the
terminal has accessed the phone system.
Methods available for transmitting the Access Code:
Send the Access Code manually via the Live Dial or Buffer Dial method.
Store the Access Code in the Phone List and send it under the Phone List.
Send the Access Code by pressing the shortcut key P1 (portable terminal) or
P5 (mobile terminal).
Note: You need to set the programmed Access/De-Access Code key via the CPS.
To Next Page
Loading...
Need help?
General
