44
Installation Guide
2. Install the duplexer onto the bracket. Be sure to observe the
specifications of two antenna interfaces on the duplexer, to
determine which one should be connected to the transmitter.
The interface connecting the transmitter should be close to PA
module to reduce RF loss, as shown below:
3. Loosen the screw at the back of the top cover, and then pull
the top cover to remove it.
4. Loosen the 6 screws locking the PA heat sink, remove all
power, data and RF cables from the PA, and fi nally remove the
PA heat sink. See the fi gure below.
5. Connect the RF cable, See the fi gure below.
6. Install the duplexer to the repeater
After the duplexer is mounted properly, fasten it with the 2
screws inside the housing and on the side respectively.
7. Then attach the PA heat sink and connect all cables.
8. Close the repeater cover.
RF CableData CablePower Cord
To Next Page
Loading...
