33
3. Parameter Confi guration
When the repeater proves to work normally, confi gure appropriate
parameters according to your actual requirements. And then you
can proceed with on-site installation.
Installation Steps
Install the repeater as follows:
1. Install the repeater at a proper location;
2. Attach all necessary accessories;
3. Ground the repeater through the Ground Screw located on the
rear panel.
Installing the Duplexer
If the repeater needs to work with a duplexer, you should
implement the following operations before installation.
1. Loosen the three screws on the bracket with a cross head
screwdriver. See the fi gure below.
Installation Guide
Proper installation can ensure optimum performance and reliability
of the repeater. Therefore, be sure to read the following instructions
before installation.
Installation Requirements
1. Installation Environment
The repeater must be installed in a dry and well-ventilated place
with ambient temperature of -30
℃
~+60
℃
and relative humidity of
less than 95%.
2. Installation Location
The repeater can be installed in a rack, bracket and cabinet or on
a desk.
3. Installation Tools
Tools required for installing the repeater include a cross head
screwdriver, a torx screwdriver and a spanner.
Note:Note: please refer to Safety Information Booklet Safety Information Booklet
for more information.
Before Installation
1. Voltage Check
Please check whether the voltage of DC power or battery meets
the repeater specifi cations.
2. Product Check
Please check whether the repeater works properly by observing
the 8 LEDs located on the front panel.
To Next Page
Loading...
