spanner.
Note: Please refer to Safety Information Booklet for more information.
Before Installation
1. Voltage Check
Please check whether the voltage of DC power or battery meets the repeater specifications.
2. Product Check
Please check whether the repeater works properly by observing the 8 LEDs located in the front panel.
3. Parameter Configuration
When the repeater proves to work normally, configure appropriate parameters according to your actual
requirements. And then you can proceed with on-site installation.
Installation Steps
Install the repeater as follows:
1. Install the repeater at a proper location;
2. Attach all necessary accessories;
3. Ground the repeater through the Ground Screw located on the rear panel.
Installing the Duplexer
If the repeater needs to work with a duplexer, you should implement the following operations before
installation.
1. Loosen the three screws on the bracket with a cross head screwdriver. See the figure below.
2. Install the duplexer onto the bracket.
Be sure to observe the specifications of two antenna connectors on the duplexer, to determine which
one should be connected to the transmitter. The connector connecting the transmitter should be
close to the PA module to reduce RF loss, as shown below:
To Next Page
Loading...
