16
Advanced Operations
Monitor
Purpose: In this mode, the receiving party can receive incoming calls from the
transmitting party regardless of CTCSS/CDCSS condition. If carrier condition
isnotsatised,thereceivingpartywillfailtoreceiveanyincomingcalls.
Operation: Press the Monitor key to enter this mode, and press it again to exit.
Monitor Momentary
Purpose: Refer to Monitor.
Operation: Hold down the programmed key continuously to enter this mode,
and release the key to exit.
Scan
The Scan feature enables a two-way radio to continuously scan each channel
for activity. Press the programmed Scan key to initiate scanning channels in
the order astheyappearin scan list. Status Indicator ashes green during
the scan process, and solidly glows when activity is detected and signaling
conditionissatisedonachannel.Pressthekeyagaintoexitscanning.
When scanning is active, the radio will continuously scan for activity on scan
list members. Once activity is detected on a channel, scanning will pause
on the active channel for you to receive activity. The channels available for
scanning are programmed by your dealer.
No Priority Channel
Providing that there is a scan list with 6 channels and all channels are non-
prioritized, the normal scan operation would proceed in the following sequence,
asshowningure9.
Priority Channel Scan
If you prioritize Channel 2 as Priority 1, the scan operation would proceed in
thefollowingsequence,asshowningure10.
Fig.9
Fig.10