5
Radio Overview
3.When signal is received on a certain channel, Status
Indicator solidly glows green.
4.Scan Exit Alert Tone (programmable by your dealer): A
beep is heard.
Power adjust 1.A low-pitched tone is heard when transmit power is
switched from high power to low power.
2.A high-pitched tone is heard when transmit power is
switched from low power to high power.
VOX 1.One beep sounds when the VOX feature is activated.
2.Two beeps sound when the VOX feature is disabled.
Battery Latch
Used to secure or remove the battery.
Audio Accessory Jack
Used to connect audio accessories such as earpieces.
Mini USB Jack
Used to connect accessories such as programming cable, cloning cable and
power cord.
Battery Information
Initial Use
New batteries are shipped not fully charged from the factory. Charge a new
battery for 5 hours before initial use. The maximum battery capacity and
performance is achieved after three full charge/discharge cycles. If you notice
the battery power runs low, please recharge the battery.
Applicable Battery Packs
To reduce the risk of injury, charge only the battery specified by the
manufacturer. Other batteries may burst, causing bodily injury and damage.
To Next Page
Loading...
Need help?
General
