Hytera TC-320 - Advanced Operations; CTCSS;CDCSS Configuration; Battery Save and Power Adjust; Timer and Monitoring Functions

15
Advanced Operations
indications representing battery strength levels. To exit the indications, release
the key.
The Status Indicator gives the following indications to represent corresponding
battery strength levels:
The LED glows different colors to represent battery strength levels:
Monitor
Squelch Off
Purpose: In this mode, the speaker is unmuted in any condition so as to
receive any sound on the current channel. When audio signal is received on
the channel, audio will be heard. Otherwise, background noise will be heard.
Operation: Press the Monitor key to enter this mode, and press it again to exit.
Squelch Off Momentary
Purpose: Refer to Squelch Off.
When audio signal is received on the channel, audio will be heard. Otherwise,
background noise will be heard.
Operation: Hold down the programmed key continuously to enter this mode,
and release the key to exit.
Monitor
Purpose: In this mode, the receiving party can receive incoming calls from the
Battery Strength Status Indication
70% - 100% Status Indicator solidly glows green.
50% - 70% Status Indicator solidly glows orange.
30% - 50% Status Indicator solidly glows red.
10% - 30% No indication is given when the programmable key is
 pressed;Statusindicatorashesredwhiletheradiois
operating.
Less than 10% No indication is given when the programmed key is
pressed. While the radio is in standby mode, Status
 Indicatorashesredandalow-pitchedtonesounds
at intervals of ten seconds. If PTT key is pressed at
the moment, the radio will give an alert indicating that
transmission is prohibited.