Hytera TC-320 - Scan

16
Advanced Operations
transmitting party regardless of CTCSS/CDCSS condition. If carrier condition
isnotsatised,thereceivingpartywillfailtoreceiveanyincomingcalls.
Operation: Press the Monitor key to enter this mode, and press it again to exit.
Monitor Momentary
Purpose: Refer to Monitor.
Operation: Hold down the programmed key continuously to enter this mode,
and release the key to exit.
Scan
The Scan feature enables a two-way radio to continuously scan each channel
for activity. Press the programmed Scan key to initiate scanning channels in
the order as they appear in scan list. Status Indicator ashes green during
the scan process, and solidly glows when activity is detected and signaling
conditionissatisedonachannel.Pressthekeyagaintoexitscanning.
When scanning is active, the radio will continuously scan for activity on scan
list members. Once activity is detected on a channel, scanning will pause
on the active channel for you to receive activity. The channels available for
scanning are programmed by your dealer.
No Priority Channel
Providing that there is a scan list with 6 channels and all channels are non-
prioritized, the normal scan operation would proceed in the following sequence,
asshowningure8.
Priority Channel Scan
If you prioritize Channel 2 as Priority 1, the scan operation would proceed in
thefollowingsequence,asshowningure9.
Fig.9
Fig.8