What to do if my Hytorc Stealth 8 Power Tool ratchet does not take successive strokes?
If the ratchet does not take successive strokes, the square drive or the ratchet spring may be defective, requiring replacement. Also, ensure the piston fully retracts. Another possible cause is damage to the linkage between the piston rod and the drive plates, which would also require replacing the defective part.
Why does my Hytorc Stealth 8 lock onto the nut?
If the tool locks onto the nut, it is likely that the square drive is loaded at full torque. Use the disengagement lever to remove the tool from the nut or bolt.
Why does ice build up at the exhaust of my Hytorc Stealth 8 Power Tool?
If ice builds up at the exhaust, the ambient temperature is likely too low. Wait 5-10 minutes to let the ice melt.
Covers overall safety guidelines for personnel, work area, and equipment.
Mandates qualified personnel, PPE, and alertness during operation.
Guidelines for using approved, compatible, and undamaged HYTORC equipment.
Details specific safety measures for pump units and hydraulic hoses.
Covers modifications, volatile atmospheres, grounding, and oil requirements.
Instructions on securing reaction arms against solid points and avoiding body parts.
Guidelines for using HYTORC sockets, avoiding impact wrench sockets, and proper fit.
Details warnings for using impact wrench sockets and ensuring correct fit.
Describes the main tool, its connections, and operational parts.
Details hydraulic hose specifications and connection types (A/B, A/R).
Illustrates correct and incorrect hydraulic hose connections using couplings.
Procedure for connecting screw-type and quick-type safety couplings.
Procedure for safely disconnecting hydraulic hoses, including depressurization.
Covers power supply requirements and warnings for 230V and 400V units.
Details connecting air supply, FRL usage, and required pressure.
Explains ATEX compliance and grounding procedures for explosion-proof systems.
Checklist for ensuring the tool and system are ready and safe for operation.
Procedure to disengage the reaction pawl for easier tool removal.
Step-by-step guide to set the desired torque using the pressure control valve.
Detailed procedure for tightening bolted flange connections accurately.
Procedure and caution for loosening bolted flange connections.
Table of common tool problems, causes, and solutions.
Addresses general pump unit issues and specific electric pump unit problems.
General| Brand | Hytorc |
|---|---|
| Model | Stealth 8 |
| Category | Power Tool |
| Language | English |
To Next Page