TECHNICAL DOCUMENT
9. Safety Precautions
The precautions described below are intended to prevent the occurrence of danger or injury to users and other personnel and to use the product
correctly. Please read and understand these precautions thoroughly before using this product.
If the drive is accidentally damaged during operation, the company is only responsible for the repair and replacement of the drive within the
warranty.
The company does not bear the loss of control or casualties and property damage caused by accidental damage to the drive.
Do not use the product with flammable materials when exposed to explosive, flammable, corrosive gases or water splashes or in a nearby
location. Doing so may result in fire, electric shock or personal injury.
Only qualified personnel should be allowed to install, connect, operate and perform inspection/exclusion of product failures. Handling of
unqualified personnel may result in fire, electric shock, personal injury or equipment damage.
Do not move, install, connect, or inspect the product while the drive is powered, and turn off the power when performing these operations.
Failure to follow these instructions may result in electric shock.
Do not use non-electromagnetic brakes in vertical applications. If the drive's protection function is activated, the motor may not stop and the
moving parts of the device may fall, resulting in personal injury or equipment damage.
Always keep the drive's power supply voltage below the rated value. Failure to do so may result in fire or damage to the drive.
Always turn off the power before performing maintenance/inspection. Failure to do so may result in electric shock.
Do not touch the connection terminals on the drive immediately after turning off the power (within 30 seconds, or until the power LED is
turned off). Residual voltage may cause electric shock.
Regularly check the dust accumulated in the open part of the cleaning drive. Accumulated dust can cause a fire.
Do not disassemble or repair the motor and drive. Doing so may result in electric
To Previous Page
Loading...
Need help?
General