IAV Light Speaker - Step 3: Test Fit Your Lightspeaker

10
Tech Support: (877) 591-2491
Step 3: Test fit your LightSpeaker
®
.
Your LightSpeaker
®
is designed to fit directly into most 5“
(R30) and 6“ (R40) down light cans by simply removing
the existing light and, in the same manner as a light bulb,
re-installing your LightSpeaker
®
in its place. You may
simply test fit your LightSpeaker
®
, or you may measure
according to the diagram below, to be certain your IAV
®
LightSpeaker
®
will fit directly into your recessed light
fixture.
This diagram shows the minimum width and depth
necessary to house your LightSpeaker
®
completely within
the recessed lighting enclosure. The depth can be less if
you do not mind your LightSpeaker
®
standing out slightly
from the ceiling.
If your LightSpeaker
®
fits directly into your recessed
lighting fixture without any modifications you can skip
forward to Step 7.
6.6”
4.75”