IAV Light Speaker - Step 7 - Setting the Zone and Stereo Switches

16
Tech Support: (877) 591-2491
If you are installing into a 6” recessed lighting fixture,
rotate each of the SimpleTabs™ out to position “A” on the
top of the LightSpeaker
®
unit.
Step 7: Setting the Zone and L/R Stereo Switches.
A) Set the zone switch on the back of the
LightSpeakers
®
to one, unless you are setting up a
two zone system. For more on zones see Step 7B:
Setting up a Two Zone System below after completing
B and C below.
B) Set the left/right stereo switch. “L” if it is the left
speaker, “R” if it is the right speaker. For additional
information see Selecting LightSpeaker
®
Locations.
C) Your LightSpeaker
®
system allows you to install up
to 4 pair of (or 8 total) speakers. If you are installing
more than one pair of LightSpeakers
®
you will
probably want to divide your home into zones.
If you are not setting up a two zone system, go to Step 8.