20
Tech Support: (877) 591-2491
Step 8: Installing your LightSpeaker
®
into the recessed
light fixture:
A) Simple Install: If you skipped steps 4-6, and your
LightSpeaker
®
fits with no modifications, screw it into
the lighting fixture. Test your circuit by turning on the
circuit breaker and light switch from Step 1. If the LED
light does not come on after 5 seconds remove and
reinstall the LightSpeaker
®
, check your circuit breaker
and try the switch again. You can now skip to Step 9.
B) Simple Tab Install: If you did not skip steps 4-6,
here’s how to use the SimpleTabs™ to install your
LightSpeaker
®
:
1) Grasp the Edison Socket with one hand, and with the
other hand screw the LightSpeaker
®
into the socket on
the pigtail. Be careful: Always turn the speaker not the
socket. Turning the socket will twist up the pigtail and
put unneeded stress on the connection.
2) Grasp the LightSpeaker
®
by the light bridge (see
section titled “Removing the Lens” below) and while
holding it level and steady, firmly push it back into the
lighting fixture. It is not necessary to use the light bridge
to install LightSpeaker
®
, so do so only if you find it
helpful.
Light Bridge
WARNING!
Be careful not to touch the
speaker when grasping the
light bridge.
To Next Page
Loading...
Need help?
General