IAV Light Speaker - Installation Guide; Fixture Preparation and Compatibility Check

9
Tech Support: (877) 591-2491
Instruction Manual
Step 1: Decide which lights will be replaced with
LightSpeakers
®
.
Your IAV
®
LightSpeakers
®
have been specifically designed
to cover large areas, however if the location of your fixtures
allow you to do so, you should think about how you use your
room and where you are likely to spend most of your time.
Then choose the fixtures that are most evenly spaced to
your preferred listening position.
A) Turn off the circuit breaker and light switch, to the
bulbs you intend to replace with LightSpeakers
®
.
B) Remove the existing light bulb.
Step 2: Check your connector
type. Your IAV
®
LightSpeaker
®
is designed to fit into a standard
Edison connector. It will not fit any
other type connector.
WARNING!
Turn off circuit breakers to all lighting
fixtures you are working on!
STOP!
Check your connector!