Manual ibaBM-DPM-S
10
Issue 2.11
4 Safety instructions
The device should not be operated at voltages exceeding +24 V DC! An overly high op-
erating voltage destroys the device and may result in death or serious injury.
The PROFIBUS cable should be connected after proper completion of the active slave
configuration only.
Please, see also chapter 9.4.4.2 “Active Slaves“ tab (Defining the slave addresses)“ and
11.2 „Active slave operating mode“.
Important note
Do not open the device!
There are no serviceable parts inside the device.
Opening the device will void the warranty.
Note
Cleaning
To clean the device, use a dry or slightly moistened cloth.
To Next Page
Loading...
Need help?
General