The WiFi network screen appears. The IBC-AHU will appear in the device’s list of WiFi
available networks as "IBC-AHU-xxxxx", where "xxxxx" is the serial number of the controller
in the IBC-AHU. If there are multiple IBC-AHUs in the area, the appliance with the strongest
signal will likely be the controller you want to connect to.
2. Select IBC-AHU-xxxxx (where “xxxxx” is the controller serial number).
3. Enter 1234567890 when prompted for a password.
Depending on the version of Android your device has, after a few seconds you may see a
warning, as shown below. You can ignore this.
With the AHU cover off, the LEDs on the circuit board will start blinking simultaneously in a
ON-OFF-ON-OFF-OFF-OFF pattern when connected.
An Android prompt may request that you make your device's location discoverable.
To Next Page
Loading...
