BIOS Setup configuration
6-9
Setup parameters
Devices and I/O Ports
Use the options in this menu to configure the devices and
I/O ports in this computer.
Diskette Drive A
Use this setting to define the type of drive installed as drive A.
PS/2 Mouse function
Determines the PS/2 Mouse function is enabled or disabled.
On Board Audio
Use this setting to enable or disable the audio function that is integrated on the
system board.
On Board LAN
Use this setting to enable or disable the local area network (LAN) function built into
the computer.
Serial Port Setup
Use these settings to define the I/O port address and interrupt-request number to
be used by the serial port.
Parallel Port Setup
Use these settings to define the I/O port address and interrupt-request number to
be used by the parallel port. These settings also control the parallel port mode (EPP,
ECP, ECP/EPP, or SPP, and the DMA setting for ECP, if used).
None No floppy drive installed
720K, 3.5 in 3-1/2 inch double-sided drive; 720 kilobyte capacity
1.44M, 3.5 in 3-1/2 inch double-sided drive; 1.44 megabyte capacity
To Next Page
Loading...
Need help?
General