The following table shows the feature code, custom card identification number, and field-replaceable unit
part number for the adapter.
Feature code (FC)
Custom card identification number
(CCIN)
Field-replaceable unit (FRU) part
number
EC41 NA 00E3980
*
Cable part number: 00E3060
*
Designed to comply with RoHS requirement
This adapter provides the following features:
v Placed in a single PCIe slot.
v The adapter is regular-height and of half-length.
v Supports the single lane (x1) PCIe 2.1 bus interface.
v Provides 512 MB DDR3 graphics memory.
v Supports DVI or VGA outputs.
v Supports two 30 inches (76.2 cm) high-resolution displays.
v Provides a DMS-59 connector that can attach to any DMS-59 breakout cable.
v One analog monitor connected that supports a maximum resolution of up to 1920 x 1200.
v One digital monitor connected that supports a maximum resolution of up to 2560 x 1600.
v Display power management: Video Electronics Standards Association (VESA), Display Power
Management Signaling (DPMS)
For details about slot priorities and placement rules, see the PCI adapter placement topic collection for
your system.
Operating system or partition requirements
If you are installing a new feature, ensure that you have the software that is required to support the new
feature and that you determine whether there are any prerequisites for this feature and attaching devices.
To check for the prerequisites, see IBM Prerequisite website (www-912.ibm.com/e_dir/eServerPrereq.nsf).
Figure 17. PCIe2 LP 3D Graphics Adapter
Managing PCI adapters 47
To Next Page
Loading...
Need help?
General