Figure 44. Partially removing the front drives and llers
a) Push the drive tab (A) to release the drive lever (B).
b) Using the drive lever, pull the drive and ller about 2.5 cm (1 in) from the system.
c) Repeat steps “5.a” on page 50 - “5.b” on page 50 for the other drives and llers.
6. Label and disconnect the signal cable (A) and the power cable (B) from the disk drive backplane as
shown in the following gure.
Unlatch the clips that secure the connectors to the disk drive backplane.
50
Power Systems: Power Systems: Drive backplanes
To Next Page
Loading...
