Key Code Qual Description
2h 40h 85h Diag Fail - RAM Microcode Not Loaded.
3h 0Ch 03h Medium error. Recommend Reassign.
3h 10h 00h Medium error. ID CRC error.
3h 11h 00h Medium error. Unrecovered read error.
3h 14h 01h Medium error. Record not found.
3h 16h 00h Medium error. Data synchronization mark error. (DAM error)
3h 19h 00h Medium error. Defect list error. A defect list error occurs when a data error
is detected while reading the manufacturing defect list or while reading or
writing the grown defect list.
3h 31h 01h Medium error. Medium Format Corrupted Reassign Failed
4h 11h 00h Hardware Error. Unrecovered read error in reserved area.
4h 19h 00h Hardware Error. Defect list error.
4h 32h 00h Hardware Error. No defect spare location available. A "no defect spare
location available sense code" indicates that the Reassign Block command
can not proceed the process because all spare sectors have been used, or it
will exceed implementation limitation of defect handling of the file.
4h 40h 80h Degrade Mode. Diagnostic Fail. Configuration sector valid check fail.
Reserved area sector valid check fail.
4h 40h 85h Degrade Mode. RAM Microcode Not Loaded.
4h 44h 00h Hardware Error. Internal target failure.
4h 81h 00h Hardware Error. Internal logic error.
5h 1Ah 00h Illegal request. Parameter list length error. The number of parameters sup-
plied is not equal to the value the expected.
5h 20h 00h Illegal request. Illegal command operation code. This command is also
returned when an unsupported command code is received.
5h 21h 00h Illegal request. Logical block address out of range.
5h 24h 00h Illegal request. Invalid field in CDB.
5h 25h 00h Illegal request. Invalid lun.
5h 26h 00h Illegal request. Invalid fields in the parameter list.
6h 28h 00h Unit attention. Not ready to ready transition.(Format completed)
6h 29h 00h Unit attention. Power on reset or Bus device reset occurred.
6h 2Ah 00h Unit attention. Parameters changed.
6h 2Ah 02h Unit attention. Log select parameters changed.
6h 2Fh 00h Unit attention. Command cleared by another initiator.
6h 3Fh 01h Unit attention. Micro code has been changed.
6h 5Dh 00h Predictive Failure Analysis threshold reached on
Bh 00h 00h Aborted command. No additional sense code.
Bh 1Bh 00h Aborted command. Synchronous data transfer error. (Extra ack detected)
SCSI SENSE DATA 209
To Next Page
Loading...
