Introduction 17
Installing and removing an SFP+ transceiver
2
Statement 3:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or transmitters) are
installed, note the following:
DANGER
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
Appareil A` Laser de Classe 1
Inserting an SFP+ transceiver
To insert an SFP+ transceiver, complete the following steps:
1. Read the safety information that begins on page vii and “System reliability guidelines” on
page 11.
2. Read the information in “Handling an SFP+ transceiver” on page 16.
3. Remove the SFP+ transceiver from its static-protective package.
4. Remove the protective insert or dust cap, if one is installed, from the port where you are
installing the SFP+ transceiver and store it in a safe place.
5. Gently insert the SFP+ transceiver in a port on the switch until it clicks into place, as shown in
Figure 5.
To avoid damage to the cable or the SFP+ transceiver, make sure you install the SFP+
transceiver before you connect the fiber-optic cable.
Some laser products contain an embedded Class 3A or Class 3B laser diode.
Note the following.
Laser radiation when open. Do not stare into the beam, do not view directly
with optical instruments, and avoid direct exposure to the beam.
To Next Page
Loading...
Need help?
General
