IBM Flex System V7000

The correct zoning provides a way for the control enclosures to have
connectivity to each other over the fabric. See the configuring topics in the Flex
System V7000 Storage Node Information Center that contain information about
zoning rules and zoning details.
If the configuration tool for the SAN switch does not provide details of the
world wide port names (WWPNs), use the service assistant to find them or you
can use the FSM or CMM to launch the console. For information about the
status of the node, see the IBM Flex System V7000 Storage Node Troubleshooting,
Recovery, and Maintenance Guide PDF on the CD that is shipped with the system.
2. Start the management GUI.
3. Go to Monitoring > System Details.
4. Select the system name in the tree.
5. Go to Actions > Add Enclosures > Control and Expansions.
6. Continue to follow the on-screen instructions.
30 Flex System V7000 Storage Node: Installation Guide