Attention: Do not turn off the autoloader until the interface is inactive.
Removing power from a SCSI peripheral when the bus is active can result in
data loss and indeterminate bus states. If your computer is connected to a
LAN, be sure to check with your system administrator before turning off the
device.
5. Turn off the autoloader. The power “standby” switch is recessed to avoid
accidental power cycles. Disconnect the power cable.
6. To ship the autoloader, remove all external cords, cables, and terminators. For
an internal move, only disconnect the power cable, remote management card
cable, and SCSI cable to the host.
Note: You do not need to remove the SCSI cable that connects the controller to
the drive module unless the autoloader is being shipped.
7. Re-install the internal packaging to secure the magazine inside the autoloader
(see“Remove the autoloader and its internal packaging” on page 5 ).
8. Place the autoloader into the original packaging box. If you no longer have the
original packaging, contact your service representative to purchase the
packaging kit.
Chapter 4. Autoloader maintenance 29
To Next Page
Loading...
Need help?
General