Chapter 1. Installation and user’s guide
The IBM
®
LTO autoloader is an automated storage and retrieval system that comes
with a preinstalled LTO tape drive, three fixed-cartridge slots, and a removable
magazine that can hold six additional tape cartridges. You can connect the
autoloader to a server externally, or you can install the autoloader in a server rack
on a fixed shelf.
The autoloader complies with the ANSI standard for the SCSI-3 LVD (low-voltage
differential) interface and has industry-standard, 68-pin, external SCSI cable
connectors. The tape media format follows ECMA-approved and ANSI-proposed
standards.
Autoloader features
In addition to this book, the option kit includes:
CD
9
10
7
8
«1¬SCSI external cable
«2¬SCSI terminator
«3¬SCSI jumper cable
«4¬AC power cord
«5¬Data cartridge
«6¬Cleaning cartridge
«7¬Quick install guide booklet
«8¬Barcode kit
«9¬Trial software CDs
«10¬Information tabs
Before you begin
The autoloader requires the following environmental conditions:
v AC power voltage: autoswitching 100-127 V or 200-240 V. Line frequency: 50-60
Hz.
v Moderate room temperate between 10-35
°
C (50-95
°
F).
v Humidity ranging from 20-80%.
v Standalone configuration includes the base enclosure and feet, and requires the
following clearances:
– Back: 56 cm (22 in.) for cooling and service
– Front: 86 cm (34 in.) for operator access
© Copyright IBM Corp. 2000 1
To Next Page
Loading...
Need help?
General