Refer to Figure 14 on page 24 for the positioning of the short or long brackets and screws.
3. Attach the brackets using four 6-32 x 1/4-in. screws.
4. Repeat step “2” on page 22 and step “3” on page 23 to attach the left rear bracket to the left
extension.
5. Adjust the brackets to the rack depth and tighten all the 6-32 x 1/4-in. screws to a torque of 9 in-lb (10
cm-kg).
Figure 13. Attaching the rear brackets to the extensions at the front of the device
1 - Rear brackets, short
2 - Screws, 6-32 x 1/4-in., panhead Phillips
Chapter 3. Mounting the switch
23
To Next Page
Loading...
