To separate the 572F/575C card set and move the cache directory card, complete the following steps.
1. Label both sides of the card before separating them.
2. Place the 572F/575C card set adapter on an ESD protective surface and orient it as shown in
Figure 32.
3. To prevent possible card damage, loosen all five retaining screws C before removing any of them.
After all five retaining screws have been loosened, remove the screws C from the 572F storage
adapter.
Important: Failure to loosen all five retaining screws prior to removing any of the screws can result
in damage to the card.
C Screws
Figure 32. 572F/575C card set adapter
Figure 33. Location of screws on the 572F/575C card set adapter
SAS RAID controllers for IBM i 45
To Next Page
Loading...
