4.
Note: Make sure the arm with junctions is facing the file module.
Place the cable management arm on the support arm. Pull out both cable
management arm pins and then slide the cable management arm tabs into the
slots on both inside and outside of the slide rail. Push the tabs until they snap
into place.
5. Make sure that the support rail is located between the 2 nail head features.
ifs00027
Figure 44. Install the cable management support arm. It can be installed on either side (left or
right). The graphic shows the rear of the rack.
Arm junctions
ifs00048
Figure 45. Install the cable management arm.
Chapter 5. Performing the hardware installation 87
To Next Page
Loading...
