6. Attach the power cords and other cables to the rear of the file module
(including keyboard, monitor, and mouse cables, if required).
Route the cables and power cords on the cable management arm î1î and
secure them with cable ties or hook-and-loop fasteners.
Note: Allow slack in all cables to avoid tension in the cables as the cable
management arm moves.
7. Insert the M6 screws to the rear of the slides. Use a cable tie to secure the free
end of the cable management arm to the rack, if needed.
ifs00049
Figure 46. Adjust the location of the cable management arm.
1
ifs00050
Figure 47. Connect and route the cables.
88 IBM Storwize V7000 Unified: Adding Storwize V7000 File Modules to an existing Storwize V7000 system 2073-720
To Next Page
Loading...
