The drives can be distinguished from the blank carriers by the color-coded striping
on the drive. The drives are marked with an orange striping. The blank carriers are
marked with a blue striping.
To replace the drive assembly or blank carrier, perform the following steps:
Procedure
1. Read the safety information to which “Preparing to remove and replace parts”
on page 85 refers.
2. Unlock the assembly by squeezing together the tabs on the side.
3. Open the handle to the full extension.
svc00612
Figure 34. Unlocking the 3.5" drive
104 Storwize V7000: Troubleshooting, Recovery, and Maintenance Guide
To Next Page
Loading...
