Adapter
Rear adapter
retention
bracket
8. If you are not replacing the adapter, install an expansion-slot cover in the
expansion-slot opening.
9. If you are instructed to return the adapter, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Installing a ServeRAID adapter
For information about the types of ServeRAID adapters that the server supports and
other information that you might consider when you install an ServeRAID adapter,
see the Installation and User’s Guide. (For the locations of the expansion slots and
connectors, see “System-board internal connectors” on page 17).
Note: If you are installing Intel Ethernet Quad Port Server Adapter I340-T4 (part
number 49Y4240), you can only install the adaptor in slot 1, slot 2, or slot 3.
To install a replacement ServeRAID adapter on 4U server models with
non-hot-swap power supplies, complete the following steps. For the 5U server
model with hot-swap power supplies (Model name: 2582-F4x), please see the next
sub-section.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 163.
2. Check the instructions that come with the adapter for any requirements,
restrictions, or cabling instructions. It might be easier to route cables before
you install the adapter.
3. Follow the instructions that come with the adapter to set jumpers or switches, if
any.
178 IBM System x3100 M4 Type 2582: Problem Determination and Service Guide
To Next Page
Loading...
Need help?
General